These are basic, industral, inexpensive air cooled engines used in a few areas like trolling
a small flat bottom fishing boat and rarely on weed eaters. If I remember right its only 2.2
hp and about 7000 rpm with governor.

I acquired them from where I work for cost, so I figured why not.

I made the water cooled cylinder jacket, header, intake manifold, and velocity stack,
and the overdrive transmission myself. Clutch is a bought item made just for weed eaters.

In my 65" Scarab deep vee I used two of these engines. I made one to run in the opposite
direction.(That had Tecumseh scratching their heads)

Next project, possibly 4 of these in my 72" cat hull. Trust me it has the room for them!