Stuff  Yahoo  |  SOS Forum  |  Diesel Sweeties  | | Cakewalk














This Page is to document the construction of some DIY corner Bass traps. The design is original (though not exactly ingenious) using information gathered from various websites and forums. This is mainly an experiment to see just how inexpensively a set of effective traps can be built.

I had a loose idea of what needed to be done and that was enough for me. The plan was to make two corner traps out of wood, each 2'x4' and 4" deep. The center would be filled with insulation and compressed then covered in fabric. Since this was a bodge job I started by making the frames the size I wanted. I would fit the design into this frame later as I needed.  


Good clean 45's


Make your joints as clean as possible and use a countersink for the best results.





Cross brace added.



Many Thanks to for providing many answers and this site's foundation!