Over 170 Molds to Choose From
As these molds are Not Flexible you will need to use some sort of mold release, when using clay to create your project. A simple release agent to use is "Talc Powder" or "Corn Starch". Be sure to brush off the powder before baking your casted piece.
Once you've brushed the cavity of your mold w/powder (be carefull not to overdo the powder and cover up the design) you are ready to make a casted piece. If you are using an oven baking clay such as Sculpey or Fimo, kneed the clay until soft and plyable before pressing into the mold cavity. Using harden'd clay and pressing too hard could cause mold to crack. Using a softened clay insures longivity of your mold.
To get your casted piece out of the mold, there are a couple of techniques to use: One way is after you have filled your mold cavity with your desired clay, smooth flat, take a small amount of clay and roll into a ball, gently press to the flat side of your piece and gently pull out, being careful not to destort your casting, trim your piece where needed and bake your clay piece according to clay manufactures directions.
Another technique is once you've dusted your mold w/powder, and pressed your clay into the cavity, Simply put your mold in the freezer, until your clay becomes somewhat hardened, shouldn't take too long, and out it pops! Ready to bake! Some people have told me that they bake thier casted piece right in the mold in the oven. However, I have not tried this technique. Once your finished piece has been baked and cooled, there are so many finishing techniques to be used to make your project complete, try using colored chaulks, a lite dusting of various colors adds such depth, you can also paint your piece with acrylic paints, or try using "Rub-n-Buffs". You may also seal your finished piece with a clay glaze. For more Clay techniques and Tips, such as using metallic powders etc., please visit your favorite clay websites. There are tons of great information on clay techniques out there.
